37
Introduction:
Evergreen ECM is designed as an aftermarket
replacement of existing PSC (Permanent Split
Capacitor), direct drive, indoor blower motors for the
purpose of increasing efficiency and comfort. For
more information on this motor please visit www.
thedealertoolbox.com. There you will also find the
complete installation manual, training videos and
other valuable information.
Evergreen motors are not approved to
replace existing ECM Variable Speed
motors,
should not be used on twinned systems
and should not be used on belt drive systems.
There are two Evergreen Models. Please make sure
to use the appropriate troubleshooting information.
See the Motor ID chart on page 7 if needed.
Evergreen IM (page 38)
This motor is dual voltage 120-240VAC, reversible,
multi-horsepower, and designed for all residential
HVAC systems less than 5 ton of cooling and 150k
BTUh of heating.
Evergreen AH (page 45)
This motor is 208-230VAC only, non reversible, and
designed for any air handler application including
package systems that do not incorporate fossil fuel.
Evergreen
®
Indoor Blower Motor Diagnostics
See the Motor ID Chart on page 7 if needed.
37
To Next Page
Loading...
