34
D. If the motor fails either of these tests or does
not spin freely when rotated by hand,
replace
the motor and control modules following the
guidelines on page 36.
NOTE: The X13
®
motor is no longer available.
Its direct replacement is the Endura
®
Pro.
Endura Pro is an exact electrical and
mechanical match to the X13. The correct
replacement Endura Pro control module
or motor and control module parts must be
ordered from the manufacturer of the HVAC unit
(furance, air handler, or package system) the
motor was removed from.
Insert the 3-pin connector back into the new
control module. A slight click will be heard when
inserted properly. This connector is keyed for
proper connection.
Attach the new control module with the plug
connections oriented down (see figure 14,
page 35), insert the appropriate bolts and tighten.
Reinstall the blower/motor assembly into the
HVAC system by following the manufacturer’s
guidelines.
Reconnect all wires and/or connectors. Make sure
individual wires are connected to proper taps.
Be certain to form a drip loop so that water cannot
enter the motor by draining down the cables (see
Figure 14 below).
Go to the “Final Installation Checks” on
pages 53-54.
5.
6.
7.
8.
9.
10.
To Next Page
Loading...
