EasyManua.ls Logo

Regal LS9 - Page 156

Default Icon
290 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
154
Operating Electric Toilet
The wall control switch is used to add water to the
bowl and to flush the toilet. Select cycle information
is noted here. For more complete information, refer
to the electric toilet operator’s manual located in the
information packet.
1. To add water (est.
17 ounces per cycle)
to the bowl before
flushing human waste
press the add water
button momentarily and
release. The system fills
but prevents overfilling
the bowl.
2. To flush the bowl
press the flush button
momentarily and
release. The attached bowl motor will injest the
waste and flush it. The cycle ends with a small
amount of water being added to the bowl to help
prevent odors. This completes the minimal water
usage flush cycle.
Wall Control Panel Blue Backlighting Description:
The holding tank icon in the lower right hand
corner of the control panel is not lighted. Toilet
system is off or not receiving power.
The holding tank icon is normally green. This
means the holding tank is less than full.
The holding tank icon is red. The holding tank is
full or near full with the flush lockout (prevents
Flush operation when holding tank is full)
activated.
Tank icon flashes.
Sleep mode (non-use for 8 hours) causes the
lights to go out. Pushing the fill or flush button
momentarily will return lighting cycle.
Single Flush Override of Flush Lockout
1. If the holding tank is full the flush lockout cycle
will not allow the bowl to be flushed and the flush
button will be lighted red.
2. For emergency use only the flush button can be
held for 8 seconds and a flush will occur. This can
be accomplished because the full sensor connected
to the holding tank is usually placed a bit below the
actual full capacity of the tank. Flushing more than
5 times using the override feature may force waste
into plumbing system. Regal is not responsible
for damage to equipment, injury or death due to
overflow of waste when flush lockout is overridden.
POSSIBLE OVERFLOWING
OF THE WASTE HOLDING TANK
CAN OCCUR DUE TO USING
THE SINGLE FLUSH OVER-RIDE FUNCTION.
FOR EMERGENCY USE ONLY.
CAUTION

Related product manuals