To Next PageTo Next Page
Need help?Do you have a question about the Regalo 1185 and is the answer not in the manual?
Locate and adjust threaded spindle rods, eliminating gap between wheel and rubber foot.
Insert the four threaded spindle rods into the corners of the gate frame.
Position gate level, expand rods to contact opening without full tightening.
Tighten all spindle rods, adjust gap, remove plastic lock spacer for proper latching.
After gate positioning, draw circles around rubber feet to mark wall cup placement.
Loosen all threaded spindle rods to remove the gate from the opening.
Use marked circles as guides to screw wall cups securely into the wall.
Reinstall gate, using the wall cups as anchoring points for spindle rods.
Pull back the thumb lock to release the locking pin, freeing the door.
Lift the door panel to clear saddles and open. Reverse steps to close.
Choose the side and remove the top and bottom threaded spindle rods.
Assemble the extension to the gate and reposition according to fitting instructions.
General| Brand | Regalo |
|---|---|
| Model | 1185 |
| Category | Indoor Furnishing |
| Language | English |
