Grandview® G800C Gas Fireplace | 79
operating instructions
Receiver Battery Replacement (if optional remote control was purchased)
Diagram 1-Remote Receiver
Diagram 2-DC Spark Box
1. Remove screen. See instructions in this manual on screen
removal.
2. Locate remote receiver (see diagram 1) located on right-
hand side of the gas valve and DC spark box.
3. Remove battery compartment door to access batteries.
4. Remove all 4 AA batteries and replace with 4 new alkaline
batteries ensuring they are the correct polarity.
5. Reinstall battery compartment door.
1. Remove screen. See instructions in this manual on screen
removal.
2. Locate DC sparker box (see diagram 2) located on right-
hand side of the gas valve.
3. Install the supplied AA alkaline battery into the DC sparker
box by opening the battery compartment door.
NOTE: The AA battery in the DC sparker box will need to be
replaced annually. If the AA battery is weak, the pilot
cannot be lit when depressing the pilot knob on the
gas valve.
4. Follow the same steps to replace AA battery.
DC Spark Igniter Battery Installation/Replacement
Remove battery cmpartment
door to install/replace AA battery
To Next Page
