14
Electrolyser: Wire the RC contact, dry contact of the Phredo
SPE on the shutter entrance of the Regul electrolysers. The
treatment while the volet is closed must be set to STOP in order to
stop the treatment when the desired redox value is reached.
(switches on the Xsel or adjust the use while the volet is closed on
iDOit, see respective instructions).
Phredo SPE - Piloting an electrolyser
The Phredo is equipped with a relay allowing to control a pump of big flow or piloting a
electrolyseur for an indoor swimming pool. Phredo SPE can control the chlorine
production of an electrolyser by measuring redox in order to maintain a properly
disinfected water. It also limits the production of chlorine, especially under firm shutter,
avoiding any risk of over-chlorination and thus protecting the equipment (liner, shutter ).
Xsel – Connector with roller shutter
iDOit – Connector with roller shutter
On the Xsel
On the iDOit
To Next Page
Loading...
Need help?
General