Regul' Electronique Phredo User Manual

15
Control of the functions
Information
How to remove the santoprene tube:
Important, for the after-sales service of a device with a pH pump, it is essential
to remove the santoprene tube to avoid spraying acid into the box during
transport.
- Remove the glass
- Pull the left soproprene tube to release it
Pulling the tube will turn the pump manually.
- Remove the santoprene tube.
To replace / change:
- Place the left part of the tube.
- Turn the pump by engaging the tube in its housing.
- Replace the pump glass.
Message
and
check up
Reading error / regulation
HS Probe, empty canister.
The display flashes: Indicates that the probe is at the
limit of operation or calibration. So change the probe.
dEF flashes: when the pH or redox in the pool does
not reach the injection setpoint.
Check:
- the can is empty
- the measurement is too far from the instruction
- Adjustment of the pool volume
To delete dEF:
- After changing the bottle or checking the
probe.
- Open the door of the and and then press the adjusting
bolt until the measurement reappears.
The display or dEF flashes
Error messages

Regul' Electronique Phredo Specifications

General

Brand	Regul' Electronique
Model	Phredo
Category	Controller
Language	English