REGULA 7027F - Marking and Sealing

16
(provided that the reader driver is already installed,
see paragraphs 2.2.3.1 and 2.2.4). If the driver has
not been installed, the indicator will light up red.
After initialization of the device and SDK libraries is
complete (see paragraph 2.2.5), the reader switches
to the standby mode and the indicator 3 turns green.
When the examined document is placed on
the reader object glass 2, the device switches to
the reading mode. In the reading mode the device
captures document images under specied illumination
conditions and transfers the obtained data to the PC.
Further data processing is performed by software
components of DR SDK and depends on the functions
specied by the User’s application (see Programmer’s
Guide to DR SDK, section 6). When the document
processing is complete, the obtained results will appear
in the application window. The examined document
can be removed from the object glass and replaced by
another document.
Reading data from the inserted document can
also be initiated via the User’s application.
1.5 Marking and sealing
1.5.1 Marking of the reader meets the requirements
of IEC 60950–1. It is located on the bottom panel of
the reader (see Figure 2) and contains the following
information:
CE marking;
manufacturer’s name and/or trade mark;
manufacturer’s model identication;
manufacturer name and address;