What to do if the lid of my REITEL Polymat doesn’t open?
If the temperature is above 100°C / 212°F, the pressure might be preventing the lid from opening. Wait until the temperature drops considerably below 100°C / 212°F. If needed, switch off the device. Ensure the device is pressureless by checking the gauge readings or the valve on the rear of the device.
Why is my REITEL Polymat Laboratory Equipment not heating or heating too slowly?
The temperature limiter may have switched off. Remove the rubber cover and press the temperature limiter after approximately 15 minutes. If this problem occurs frequently, it is recommended to inform customer service.
What to do if my REITEL Polymat heats without water and is set below 30 °C / 86°F?
Fill the device with water or deactivate the heating by pressing the key „U“ of the controller for 3 seconds. Avoid activating the heating during dry operation (without water).
Why is the lid of my REITEL Polymat untight?
The lid might be untight because of the o-ring. You can try the following: - Clean the o-ring. - Grease the o-ring and sealing rim, referring to the maintenance chapter for appropriate grease. - Check if the o-ring fits tightly. - Replace the o-ring if necessary.
What to do if my REITEL Laboratory Equipment doesn’t turn on?
Check the fuses in the building and also check the device’s fuse.
Why is the lid of my REITEL Polymat Laboratory Equipment untight due to high tank pressure?
The pressure regulator may be adjusted too high. The maximum pressure should be 6 bar.
What to do if the lid of my REITEL Polymat is untight because the knurled screws are not tight enough?
Fasten the knurled screws on top of the lid handtight.
What to do if the lid of my REITEL Polymat is untight because the locking pin was set too high?
Remove the Allen screw and turn the locking pin to the right to reduce the gap.
Lists standard components included with the POLYMAT.
Details optional accessories for the POLYMAT unit.
Identifies and labels the various parts of the POLYMAT device.
Provides specifications like voltage, power, dimensions, and operating parameters.
Outlines general safety precautions for operating the POLYMAT device.
Details specific safety warnings and precautions for POLYMAT operation.
Explains the function of the control panel and its associated keys.
Step-by-step instructions for physically installing the POLYMAT unit.
Instructions for connecting the POLYMAT unit to the power supply.
Details how to set and store desired temperatures using the control panel.
Describes the process for polymerisation at temperatures below 100°C.
Explains the procedure for polymerisation at temperatures above 100°C.
General| Brand | REITEL |
|---|---|
| Model | Polymat |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
