5
Start-up and Control
The adjustment of the trigger influences the output
quantity and the lever stroke. The trigger can be adj usted
with a screw driver at the "Screw for Adjusting Trigger"
on the left casing side. The longer the lever stroke, the
more glue can be dispensed with one stroke and vice
versa.
Applying Hot-Melt
Make yourself familiar with applicator first. Apply a little
glue in varying forms on a piece of paper or cardboard;
for example dots and beads. Always keep the working
temperature of the specific hot-melt glue. This
temperature is indicated in the technical datasheet of the
hot-melt glue.
The quantity to be applied is determined by pulling the
trigger: the more you pull the more glue flows out.
Loading Hot-Melt
The MS 200 glue applicator must only be used to
dispense non-reactive hot-melts with a viscosity of 1000
up to 15.000 mPas*. Never feed other materials, dirt or
sharp objects like small fragments of metal. The hot-melt
glue applicator is only capable of working with all non-
reactive hot-melt types which are designed for working
temperatures of up to max. 200 °C.
After the end of the heat-up period (approx. 10 min.),
open the lid and load granulate up to just under the
lower rim of the feeding opening.
Close the lid and allow the applicator to melt the glue.
After the end of the heat-up period (approx. 5 min.),
open the lid by turning the star grip counter clockwise.
Load granulate up to 1,5 cm (~ 0.6 inch) under the lower
rim of the feeding opening.
Shut the lid, turn the stargrip clockwise until it is closed
and allow the applicator to melt the glue.
Wear protective gloves and safety
goggles whenever you work with the
applicator.
Never start working before fitting a nozzle
first.
Never direct the glue jet towards people!
MS 80
MS 200
*less than 1000 and more than 15.000 mPas possible with limitations.
Do not start working before the glue has molten. Partially
molten glue is thick and it needs a lot of force to press it
off the applicator. Doing so would damage the applicator.
Always deposit the glue applicator on the wire stand or
the respective plate destined for this purpose.
The glue applicator must not be laid on its side.
Do not open the lid before the applicator has warmed up.
When your skin got into contact with hot
glue, cool it with cold water immediately.
Do not try to remove the hot-melt from the
skin first. If necessary, consult a doctor.
When hot adhesive got into your eyes,
immediately cool them under running water for about 15
minutes. Consult your doctor at once!
All manuals and user guides at all-guides.com
To Next Page
Loading...
