1
SECTION 1
INTRODUCTION
1.0 General - This manual familiarizes the user with
the three phase, MinPak Plus DĆC VS drive controlĆ
ler. (Refer to Figure 1.1.) It describes assembly and
POWER
ON/OFF
CIRCUIT
BREAKER
LOCAL OPERATORS
CONTROL
SUPER
RPM
DĆC MOTOR
Figure 1.1 Ć MinPak Plus Controller and Super
RPM Motor
installation procedures, gives a general overview of opĆ
erations, and contains information on troubleshooting,
maintenance, the ordering of spare parts, and specifiĆ
cations.
The manual should be read before performing installaĆ
tion or startĆup activities. Also, there are certain fundaĆ
mental warnings which must be kept in mind at all
times. These are:
DANGER
THE DRIVE SYSTEM SHOULD BE INSTALLED,
ADJUSTED AND SERVICED BY QUALIFIED
ELECTRICAL MAINTENANCE PERSONNEL FAĆ
MILIAR WITH THE CONSTRUCTION AND OPĆ
ERATION OF ALL EQUIPMENT IN THE SYSTEM.
PERSONAL INJURY AND/OR EQUIPMENT
DAMAGE MAY OCCUR IF INDIVIDUALS ARE
NOT FAMILIAR WITH THE HAZARDS RESULTĆ
ING FROM IMPROPER OPERATION.
DANGER
CONTROLLER EQUIPMENT IS AT LINE VOLTĆ
AGE WHEN AĆC POWER IS CONNECTED TO
THE POWER UNIT IN THE MINPAK PLUS CONĆ
TROLLER. THUS AĆC POWER MUST BE REĆ
MOVED FROM THE UNIT BEFORE IT IS SAFE
TO TOUCH INTERNAL PARTS OF THE CONĆ
TROLLER. PERSONAL INJURY MAY RESULT
UNLESS POWER IS REMOVED.
WARNING
THE NATIONAL ELECTRICAL CODE REQUIRES
THAT AN N.E.C. APPROVED CLASS KĆ5 FUSED
DISCONNECT SWITCH BE USED AHEAD OF
THE CONTROLLER AND POWER TRANSFORMĆ
ER (IF USED) ON THE INCOMING AĆC LINE.
PERSONAL INJURY MAY RESULT IF AN EASILY
ACCESSIBLE MEANS OF LINE VOLTAGE DISĆ
CONNECTION IS NOT PROVIDED.
WARNING
DO NOT OPERATE THE MINPAK PLUS CONĆ
TROLLER ON POWER SUPPLIES WITH AVAILĆ
ABLE SHORTĆCIRCUIT CURRENTS IN EXCESS
OF 5000 AMPERES. DAMAGE TO EQUIPMENT
AND PERSONAL INJURY MAY OCCUR.
To Next Page
Loading...