Reliance electric MinPak Plus - Figure 4.4 - Regulator Module Pots

Page
TABLE OF CONTENTS
i
SECTION 1
INTRODUCTION 1............................................................
1.0 General 1..................................................................................
SECTION 2
GENERAL CONTROLLER INFORMATION 3.....................................
2.0 General 3..................................................................................
2.1 Operator's Control Station 3.................................................................
2.2 DĆC Drive Motors 4.........................................................................
2.3 Modification Kits 4..........................................................................
2.4 Specifications 4............................................................................
2.4.1 Line Frequency 4......................................................................
2.4.2 Voltage Tolerance 4....................................................................
2.4.3 Line Impedance Requirements 4........................................................
2.5 Enclosure 5................................................................................
SECTION 3
INSTALLATION 9..............................................................
3.0 General 9..................................................................................
3.1 Layout Guidelines 9.........................................................................
3.2 Mounting 11................................................................................
3.3 Power Wiring 11.............................................................................
3.4 Isolation Transformers 11.....................................................................
3.5 HP/Current Jumper 13.......................................................................
3.6 Regulation Mode Jumper 13..................................................................
3.7 Overspeed 14...............................................................................
SECTION 4
STARTĆUP AND ADJUSTMENT 17...............................................
4.0 General 17..................................................................................
4.1 Power Off Inspection 17......................................................................
4.2 Motor Ground Check 18......................................................................
4.3 Power On Adjustments 18....................................................................
4.3.1 Regulator Module Pots 19...............................................................
4.3.2 Maximum Speed (Voltage) 19............................................................
4.3.3. Minimum Speed (Voltage) 20............................................................
4.3.4 Acceleration and Deceleration Rates 20...................................................
4.3.5 Current Limit 20........................................................................
4.3.6 IR Compensation 20....................................................................
SECTION 5
TROUBLESHOOTING 21........................................................
5.0 General 21..................................................................................
5.1 Wiring Errors 21.............................................................................
5.2 AĆC Line Problems 21........................................................................
5.3 Motor Problems 22..........................................................................
5.4 Mechanical 22...............................................................................
5.5 Controller Malfunctions 22....................................................................
5.6 Schematics, Diagrams 22.....................................................................
SECTION 6
REPLACEMENT PARTS 45......................................................
6.1 General 45..................................................................................