EasyManua.ls Logo

Reliance HS 7000 - 3.3. Chair Top Movement

Reliance HS 7000
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AUTO
RETURN
BACK
RECLINE
BACK
RAISE
LIFT
DOWN
UP
LIFT
FIGURE 3
Footswitch Operation
REMARQUE : Les interrupteurs RAISE (LEVER) et
LOWER (BAISSER) la base sur l’interrupteur au pied
sont programmables. Selon la conception initiale,
le mouvement de la chaise S’ARRÊTE lorsque l’un
ou l’autre de ces interrupteurs est relâché. Si vous
désirez que le mouvement de la chaise CONTINUE,
après que l’un ou l’autre de ces interrupteurs est
relâché, consultez la section 4 pour connaître les
instructions de programmation.
3.3. Chair Top
3.3.1. An electric motor supplies power for the movement
of the chair top.
3.3.2. Raising & Reclining the Chair Top with
Membrane Switches.
The chair top may be raised or reclined by Membrane
Switches on either side of the chair back (Figure 2).
To lower, depress the triangle-shaped DOWN arrow
located BELOW the “TOP”. This is called the LOWER TOP
or RECLINE switch.
To raise the chair top from these switches, depress the
triangle-shaped UP arrow located ABOVE the next “TOP”.
This is called the RAISE TOP switch.
NOTE: The RAISE and LOWER/RECLINE switches
on the Chair Back are programmable. By design,
the motion of the Chair will CONTINUE when either
of these switches is released. If you want the motion
of the Chair to STOP after either of these switches
is released, then see Section 4 for programming
instructions.
REMARQUE : Les interrupteurs RAISE (LEVER)
et LOWER/RECLINE (BAISSER/INCLINER) sur
le dossier de la chaise sont programmables.
Selon la conception initiale, le mouvement de la
chaise CONTINUE lorsque l’un ou l’autre de ces
interrupteurs est relâché. Si vous désirez que
le mouvement de la chaise S’ARRÊTE, après
que l’un ou l’autre de ces interrupteurs est
relâché, consultez la section 4 pour connaître les
instructions de programmation.
CAUTION - ANY chair movement that
CONTINUES after the switch is released may
be stopped by depressing the STOP switch
or by depressing the same switch a second
time.
PRÉCAUTION : TOUT mouvement de la
chaise qui CONTINUE après que l’interrupteur
est relâché peut être arrêté en appuyant sur
l’interrupteur STOP (ARRÊT) ou en pressant le
même interrupteur une seconde fois.
3.3.3. Raising & Lowering the Chair Top From the
Footswitch.
For operation from the footswitch (Figure 3), depress
the right side of the left-hand pedal to raise the chair
top.
Depress the left side of the left-hand pedal to lower/
recline the chair top.
NOTE: the RAISE and LOWER/RECLINE switches
on the footswitch are also programmable. The
motion of the chair will STOP when either of these
switches is released. If you want the motion of the
chair to CONTINUE after either of these switches
is released, then see Section 4 for programming
instructions.
IN-7000
9

Table of Contents