What to do if my REMEHA Gas 120 ACE is fully blocked?
If your REMEHA Boiler is fully blocked, it could be due to an external cause, so remove the external cause. It could also be due to a wrong parameter set, so check the parameters. Finally, it could be due to a bad connection, so check the connection.
What to do if my REMEHA Gas 120 ACE shows a Release Signal error?
If your REMEHA Boiler shows a Release Signal error, it could be due to an external cause, so remove the external cause. It could also be due to a wrong parameter set, so check the parameters. Finally, it could be due to a bad connection, so check the connection.
What to do if REMEHA Boiler displays Funct device lost error?
If your REMEHA Boiler displays a 'Funct device lost' error, it means a functional device has been disconnected. You should run a PCB auto-detect. Also, check the wiring and connectors for bad connections. If the problem persists, the SCB PCB might be faulty and need replacement.
What to do if REMEHA Gas 120 ACE Boiler displays Uncritic device lost error?
If your REMEHA Boiler displays an 'Uncritic device lost' error, it indicates that an uncritical device has been disconnected. Run a PCB auto-detect to resolve this. Also, check the wiring and connectors for any bad connections. If the issue continues, the SCB PCB might be faulty and require replacement.
To Next Page
General