Remington i-LIGHT PRO - Light Cartridge and Intensity Settings; Light Cartridge Information; Intensity Level Selection; Testing the i-Light Device

ENGLISH
8
WARNING: ALWAYS ensure the unit is OFF and the power cord is disconnected before
removing the nose cone. If the nose cone is removed while the unit is powered ON, all indicator
lights on the base unit will flash and audible “beeps” will sound.
Getting acquainted with i-Light
Light Cartridge (fig. 1-15)
Eachlightcartridgehasalifeof1,500ashes.Whenallasheshavebeenused,thecartridgemustbereplaced.
Replacement model: SP-6000 SB
Intensity Level Selection (fig. 1-6)
Thei-Lightdeviceisequippedwith5intensitylevels.Level1isthelowestsettingandlevel5isthe
highest setting.
TIP: For the most effective results, always use the highest intensity level that does not cause
discomfort on the skin. To determine the intensity level being used, observe the number of
lights illuminated on the Intensity Level Selection Display.
Youri-LightdevicewillautomaticallybesettoIntensityLevel1eachtimethedeviceispoweredON.
To change the level, press the Intensity Level Selection Button.
Test the i-Light device on your skin (fig. 5)
1. Review the Warnings and Safety Precautions.
2. Familiarise yourself with the features of the i-Light device.
3.ConsulttheSkinToneCharttoensureyourskincolourisintheacceptablerange.
4. Place skin of the intended treatment area on skin tone sensor( touching the skin tone sensor).
If your skin is suitable, the appliance will beep and switch on.
If your skin is unsuitable, the appliance will buzz and remain off.
5. Test the i-Light device on a small patch of skin and wait 48 hours to ensure there are no
adverse reactions.
IPL6000_IB_BOOK_UK_ONLY.indd 8 1/12/11 14:55:49