Remington i-LIGHT PRO - Prepare for i-Light Treatment; Skin Preparation for Treatment; Device Setup and Activation; i-Light Operating Modes

GB
ENGLISH
9
Treat desired area(s) with the i-Light device
Prepare your skin for treatment
1. Ensure the area to be treated is clean and free from oils, deodorants,
perfume, make up, lotions and creams. Shave the hair from the area to
be treated.
2. Neverusewax,epilation,tweezers,ordepilationproductstoremovethehair
because they counteract the IPL process.
Prepare the device for treatment
3. Unwrapthehandpiececordfromthei-Lightbaseandrestthehandpiecein
the base cradle. Locate the power switch on the i-Light base and ensure the
unitisOFF.Connectthepowercordtothei-Lightbaseatthepowerinlet.
Connectthepowercordtothewalloutlet.TurnthepowerswitchON(g6).
4. Usetheskinsensortounlocktheunit.
You must unlock the unit on each body part you wish to treat.
5. Select the desired intensity level.
Treat desired area(s) with the i-Light device
Thei-Lightdeviceisequippedwithtwooperatingmodes:SingleFlashModeandMulti-FlashMode.Your
i-LightdevicewillautomaticallybesettoSingleFlashModeeachtimethedeviceispoweredON.
SingleFlashMode:Thei-LightdevicewillashoncewhentheFlashButtonispressedANDtheskin
contact sensor is engaged.
Multi-FlashMode:Thei-Lightdevicewillashonceevery2secondswhentheFlashButtonispressedAND
the skin contact sensor is fully engaged.
TheMulti-Flashmodeallowsyoutoquicklytreatlargeareassuchasthelegs,chestorbackbysimply
glidingthehandpiecetoanewlocationaftereachash
.
IPL6000_IB_BOOK_UK_ONLY.indd 9 1/12/11 14:55:49