11
How to use i-LIGHT
®
PRO+ Face & Body
1. Shave the area to be treated. Ensure the area to be treated is clean and free from oils, deodorants,
perfume, make up, lotions and creams.
2. Unlock the system by placing the intended treatment area against the skin tone sensor for a few seconds.
3. Select the energy level.
4. Press the hand piece rmly against the skin, ensuring that the skin contact sensors are in full
contact with the skin.
After you hear a series of high pitched beeps press the ash button to treat the skin.
When a ash is delivered, you will:
– See a bright ash of light.
– Hear a "POP" sound.
– Feel a mild sensation of warmth and tingling.
Lift the hand piece off the skin and move it to the next area to be treated.
OR keep the ash button depressed and slowly slide the hand piece on your skin to the next area to
be treated.
5. To make sure you have treated all areas, release the ashes close to each other in a grid pattern.
DO NOT ash the same treatment spot multiple times during one session.
6. To ensure that all hairs in the growth cycle are treated, we recommend initially using
i-LIGHT
®
PRO+ Face & Body for 3 treatments every 2 weeks, for missed hairs or hairs that have
recently become active repeat treatment as required. Do not treat the same part more often than
2 weeks. Note after a hair follicle is treated, it can take one to two weeks for the hair to fall out.
During this time, it may look like hair is still growing, but really the hair is being “pushed out.”
To Next Page
Loading...
