Remington MB320C - Trimming the Nape of Your Neck; Removing the Cutting Assembly; Replacing the Cutter Assembly; Tips for Best Results

6
TRIMMING THE NAPE OF YOUR NECK
Note: You will need a hand mirror for this operation if performing it alone.
• Remove the trimmer comb attachment.
• Use your ngers to lift the hair at the base of your head up o the neck. Your index
nger should be covering the roots of the hairs you are lifting to prevent accidental
removal by trimmer.
• Using your other hand, hold the trimmer to the base of your neck with the cutting
unit facing up and move the trimmer up the length of the neck until it touches your
nger, covering the hair roots at the base of your head.
• Be sure to move the unit slowly when performing this operation and to keep the
hair roots at the base of your head out of the way of the trimmer.
REMOVING THE CUTTING ASSEMBLY
• Remove the cutting assembly by rmly pushing up on the blade with your thumb.
REPLACING THE CUTTER ASSEMBLY
• Hold the trimmer in one hand. With your other hand, insert the lower part of the
cutter assembly into the trimmer, push down the cutter until rmly attached.
TIPS FOR BEST RESULTS
• Beard, moustache and sideburn hairs should be dry.
• Avoid using lotions before use.
• Comb your hair in the direction that it grows.
• Remove the trimmer comb attachment if you are; dening hairline edges such as
sideburns, trimming the nape of your neck or trimming your beard line on
front of neck.
CARE FOR YOUR TRIMMER
• Care for your product to ensure a long lasting performance.
• Your trimmer is tted with high-quality, cutting blades that are permanently
lubricated.
• Cleaning should only be done with a soft brush.
AFTER EACH USE
• Turn the groomer o.
• Remove the trimmer comb attachment and cutter assembly.
• Gently brush the remaining hairs away from the trimmer comb and trimmer blade.
• Please note, the main body of the trimmer is not washable and should be kept away
from water.
• After rinsing under a tap ensure the blades are dry.