Remington MB320C - Pop-up Trimmer; Cleaning Cautions; Storage; Troubleshooting

7
POPUP TRIMMER
• Remove the trimmer comb attachment.
• Slide up the pop-up trimmer into operating position.
• Brush hair from the trimmer blades and the surrounding area.
CLEANING CAUTIONS
• Only the adjustable trimmer comb and cutter assembly may be removed from the
trimmer for cleaning.
• Cleaning should only be done with a soft brush.
• Do not use harsh or corrosive cleaners on the units or their blades.
• This trimmer is not washable. Do not rinse under water.
• Do not submerge in water as damage will occur.
STORAGE
• Store this appliance and cord in a moisture-free area. Do not store it in
temperatures exceeding 140°F (60°C).
• Do not wrap the cord of the charging adaptor around the appliance.
TROUBLESHOOTING
The trimmer does not work when turned on:
• Trimmer must be charged for a full 14-16 hours. If this does not work, contact
Remington® Service Centre.
Trimmer blades do not move:
• The cutting unit may be dirty and clogged.
• Clean and lubricate the unit.
BATTERY REMOVAL
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the mains supply when removing the battery.
1. Turn the trimmer on and discharge all remaining power.
2. Remove the comb and cutter assembly.
3. Use a screwdriver to pry out the holder plate under the trimmer carefully.
4. Use a screwdriver to pry the two side panels carefully.
5. Remove the 4 screws from the housing.
6. Using a screwdriver carefully pry apart the top and bottom housing.
7. Unscrew the 2 screws on the circuit board.
8. Remove the upper circuit board.
9. Disconnect the battery from the low circuit board.
• The battery is to be disposed of safely.