Firmly insert the power cord into the power plug at the base of the shaver. When doing this for the first time the plugs
may be tight at the pin connection points, proceed to insert the plug firmly until it is in place and will not disconnect
when gently tugged.
1. Switch the On/Off button to activate for shaving (Diagram A).
2. Hold the shaver so that all the heads touch your face together (Diagram B). This allows the shaver to work the
way it was designed for the closest shave and minimum wear. Avoid holding the shaver at an angle so that
only one head touches the skin. Use short, circular strokes. Use your free hand to stretch your skin. This
encourages your whiskers to stand out, making it easier for them to enter the cutting chamber. Never press
hard when shaving. Pressing hard only flattens the whiskers, which makes it harder for them to enter the cutting
chamber. It will also cause the cutting surface to wear out more quickly.
3. Switch the On/Off button to turn the shaver off (Diagram A).
SHAVING TIPS
Wait at least 15 minutes after getting up before shaving, to ensure your face is free of puffiness that may be
present from sleeping.
Always hold the shaver at a right angle to the skin so that all three heads are touching the skin with equal
pressure.
Stretch the skin with the freehand so hairs stand upright, making it easier for them to enter the cutting chamber.
Use moderate to slow, circular stroking movement.
The use of short, circular motions in stubborn areas may obtain a closer shave, especially along the neck and
chin line.
Do not press hard against the skin to avoid skin irritation and/or damage to the rotary heads.
As with every shaver, your shave will improve over time. Allow up to four weeks of daily shaving to develop an
effective shaving style and for your skin to adjust to the new shaver. The adaptation period might take a little
longer if your skin is sensitive, if you are switching from a different method of shaving, or if you alternate
between shaving methods.
TRIMMING
Pop-up Trimmer:
1. Push the trimmer release button to engage the trimmer.
2. Trim long, difficult hairs and sideburns.
3. Close the trimmer by pressing down.
Note: Lubricate teeth with oil every 6 months.
CLEANING & MAINTENANCE
Daily Cleaning
1. Open the shaver head by pressing the release button on the front of the shaver (Fig. A) and flipping open the head
away from the body of the shaver (Fig. B).
2. Tap out excess hair shavings.
3. Close the head assembly (Fig. C).
Monthly Cleaning
To Next Page
Loading...
