Power System Cordless (Rechargeable)
Initial Charge Time 4 Hours
Full Charge Time 4 Hours
Cordless Shave Time 60 Minutes
Indicators LED
Voltage Type Worldwide
Waterproof Yes
Replacement Part No. SPR-R3500AU
Power System: Cordless – shaver can only be used without the power cord. The shaver will not run while it is
charging.
Indicators: Lights display the battery charge level
Low Charge: LED light will flash red to indicate the shaver needs to be recharged. There is less than 3 minutes
of run time remaining.
Charging: LED light will pulse green to indicate the battery is taking charge.
Full Charge: When fully charged the LED will light up green for 5 minutes and then turn off.
Voltage Type: Worldwide Voltage – shaver automatically adapts to an outlet voltage between 100V and 240V.
Note: Some countries will require the use of a plug adaptor that is not included with your shaver.
CHARGING
Before using, read the important safety instructions in this manual.
1. Ensure the product is switched off. Connect the shaver to the adaptor (Diagram A). A B C 6
2. Connect to the mains (Diagram B) and charge for at least 4 hours when using for the first time (Diagram C).
This first charge is important to the shaver’s battery life.
3. When plugged, the charging indicator will light up.
4. When empty, the battery should be charged for 4 hours, and will provide 60 minutes of shaving time.
5. To preserve the life of the batteries, allow the shaver to fully discharge every six months, and then recharge
them for 24 hours
6. Do not shave in the shower with the power cord plugged into the shaver
Caution:
Make sure the shaver and your hands are dry when charging the shaver.
Always charge the shaver in a cool, dry place.
SHAVING
1. Press power button to turn on. (Diagram D)
2. Shave face and neck using short, circular strokes. (Diagram E)
To Next Page
Loading...
