3. After shaving, turn the shaver off. (Diagram D)
SHAVING TIPS
The Remington® Power Series R3 is waterproof. You may use shaving foam or gel with your shaver. You may
also shave in the shower.
Wait at least 15 minutes after getting up before shaving, to ensure your face is free of puffiness that may be
present from sleeping.
Always hold the shaver at a right angle to the skin so that all three heads are touching the skin with equal
pressure.
Stretch skin with the free hand so hairs stand upright, making it easier for them to enter the cutting chamber.
Use moderate to slow, circular stroking movement.
The use of short, circular motions in stubborn areas may obtain a closer shave, especially along the neck and
chin line.
Do not press hard against the skin to avoid skin irritation and/or damage to the rotary heads.
As with every shaver, your shave will improve over time. Allow up to four weeks of daily shaving to develop an
effective shaving style and for your skin to adjust to the new shaver. The adaptation period might take a little
longer if your skin is sensitive, if you are switching from a different method of shaving, or if you alternate
between shaving methods.
TRIMMING
Pop-up Trimmer:
1. Push trimmer release button to engage trimmer. (Diagram F)
2. Trim long, difficult hairs and side burns.
3. Close trimmer by pressing down. (Diagram G)
Note: Lubricate teeth with oil every 6 months.
CLEANING & MAINTENANCE
Daily Cleaning:
1. Open the shaver head by pressing the release button on the front of the shaver (Fig. H) and flipping open the
head away from the body of the shaver (Fig. I).
2. Tap out excess hair shavings.
3. Rinse the head of the shaver in running water.
4. Close the head assembly.
Monthly Cleaning:
Perform cleaning steps 1 and 2.
Hold the shaver upside down so that the open cutter assembly is facing towards you. Slide the blue cutter
support frame upwards towards the shaver to release it from the assembly (Fig. J).
Pull the cutter support frame away from the inner cutters (Fig. K).
Thoroughly brush hairs from the inner and outer cutters. Rinse out remaining debris (Fig. L).
Place the cutter support frame back into position and lock into place (Fig. M-N).
Align the spring hinge into the slot at the back.
Warning:
Detach the power adaptor from the shaver before cleaning in water.
Shaver heads are suitable for cleaning under an open water tap.
To Next Page
Loading...
