RENA Address Printer
612s(Ei1)_Operations Rev: 5/12/03 34
SPECIAL FUNCT.
AUTO LF
This defines how the printer should interpret the control characters
CR = Carriage Return
LF = Line Feed
FF = Forward Feed
The settings mean:
off: CR = CR LF = LF FF = FF
on_1: CR = CR + LF LF = LF FF = FF
on_2: CR = CR LF = CR + LF FF = CR + FF
on_3: CR = CR + LF LF = CR + LF FF = CR + FF
HEX TO ASCII
If the conversion is switched on, the printer interprets the percentage sign
“%“ as a non-printable control character. The two characters following the
% sign are interpreted as HEX values, e.g. %0C = Form Feed.
LINE MODE
This permits the address to be separated by a specific number of lines.
STX-ETX
If this function is active, only the text positioned between the ASCII (02)
and the ASCII (03) control characters is printed.
STX = Start text ETX = End text
OFFSET EDGE
Offset of the measured paper edge by between 0 and 304 mm. To the
user it looks as if the left margin has been extended. This offset is
required in the event of:
• Windows programs in which the left margin cannot be changed,
• Printing of large envelopes with Windows serial print if the desired
print position cannot be set on the PC.
WARMING
Function for heating the print nozzles.
off = No heating
on = Heating on during the print process
pre = Heating and pre-heating before starting the print process
PAPER TIME-OUT
on = the paper transport is stopped immediately after the print job has
been completed and or if the printer does not detect material to print on
(no paper) within ~30 seconds.
To Next Page
