RENA Address Printer
612s(Ei1)_Operations Rev: 5/12/03 6
1.3 Handling the print cartridges
• Keep all print cartridges out of the reach of children.
• Under normal circumstances, ink cannot run out of a cartridge. Wash
off any ink spray which gets onto the skin immediately under running
water. If any ink gets into your eyes, rinse it out immediately with
plenty of water.
• The ink cartridge should not be shaken, allowed to drop, or be struck
against the palm of the hand or a hard surface.
• Install the print cartridge immediately after removing the protective
tab. Be sure not to exceed the expiry date.
• Do not try to open or re-fill an ink cartridge. This could damage the
printer.
• Clean the ink cartridge as described in Section 9.4 – Notes on
maintenance.
1.4 Location of the printer
• When setting up the printer, ensure that it is placed on a smooth and
level surface which is wider than the printer.
• The surface on which the printer stands must be sufficiently stable. If
the printer tips or is dropped, this may lead to injury or damage the
printer.
• Select an installation or storage location which protects all parts of
the printer from extreme temperature and humidity fluctuations,
direct sunlight and excessive heat.
• The printer must not be exposed to vibrations or shocks.
• Place the printer so that you can pull the power plug from its socket
easily at any time.
1.5 Disposal
• The printer may not be disposed of as an item of domestic refuse. Its
disposal must be carried out on the basis of the statutory
requirements.
To Next Page
