Rena Envelope Imager I - Error Messages and Warnings

RENA Address Printer
612s(Ei1)_Operations Rev: 5/12/03 45
9.3 Error messages and warnings
9.3.1 Error messages
Error message Description Solving the problem
ERROR LCA INITIALIS.
CALL SERVICE
Error in loading the hardware into
the XC5210 module
- Check connection on/to print
board of Module XC5210
ERROR LCA1 Ready
CALL SERVICE
Error in printing – module XC5210
- Module XC5210 may need to be
replaced.
ERROR LCA2 Ready
CALL SERVICE
Printing error. The number after
„LCA“ shows which module
ERROR LCA3 Ready
CALL SERVICE
is responsible
ERROR PEN BOARD#
CALL SERVICE
Error Pen Board, #1,2 oder 3 - Pen Board(s) may need to be
replaced
NO PAPER !! No paper in feed - Insert paper
PAPER JAM OR
WRONG PAPER LENGHT
Paper jam, or an incorrect format
was set
- Set paper feed correctly
- Meassure paper format and lock
the setting
NO INK !!
CHANGE PRINTHEAD #
The cartridge is empty. #1,2,3
#shows the number of the cartridge.
- Insert new cartridge and reset
the counter.
CHECKSUM ERROR !!
MAKE DEFAULT RESET
Error in buffered RAM. - Perform Default Reset (Power
on while holding down prog key)
CHECKSUM ERROR !!
MAKE COUNTER RESET
CHECKSUM ERROR !!
TESTMACRO RESET
CHECKSUM ERROR !!
SETTING RESET