98CUP_2013 Release
C-5
NOTE : The chassis number must correspond to the roll cage number. These 2 parts are
indissociable. It is strictly forbidden to change them separately.
The non respect of this rule is a technical non conformity
B.1.3 HOLOGRAMS
The bodywork parts and certain mechanical
components are identified using embossed
hologram disks (see Appendix/List of
marked parts).
The wording “NO PAINT ” indicates you
must not paint over the hologram under any
circumstances.
The presence of the holograms is
mandatory. The absence of hologram(s)
may be regarded as technical non-
compliance and event organizers may
require that the part(s) in question be
replaced.
B.1.4 MARKINGS
Certain mechanical components are
identified using an engraving (see
Appendix/List of marked parts).
An engraving is proof that the part is
genuine, but does not confirm that it
complies with regulations.
The absence of engraving(s) may be
regarded as technical non-compliance and
event organizers may require that the
part(s) in question be replaced.
Supplier engraving examples :
Renault Sport engraving :
To Next Page
Loading...
