1
A
2
3
4
18BBIUDB*T[G 3DJH
CLIO nu665-3
C:\Documentum\Checkout\nu665-3_eng_T5.WIN 23/8/2001 10:24
-page10
5.10
SINGLE LENS FRONT LIGHTS: replacement of the bulbs
Main beam/dipped beam
Unclip bulb connector 1.
Remove the plastic cover A.
Unclip spring 4 and remove the
bulb.
Type type of halogen bulb: H4,
approved by our Technical
Department (see panel).
Do not touch the glass of the
halogen bulb. Hold it by its base.
When the bulb has been replaced,
ensure that the coverA is correctly
repositioned.
Front side lights
Give the bulb holder 2 aquarterturn
to allow you to reach the bulb.
Bulb type: W 5 W.
Direction indicator lights
Turn the bulb holder 3 by a quarter
turn and remove the bulb.
Bulb type: 21 W, pear-shaped,
bayonet type, orange.
Cleaning headlights
As the headlights are made of
plastic “glass”, use a soft cloth or
cotton wool to clean them.
If this does not clean them properly,
use a soft cloth or cotton wool
slightly moistened with soapy water
andthenwipecleanwithasoft
damp cloth.
Finally, carefully dry off with a soft
dry cloth.
Cleaning products containing
alcohol must not be used under any
circumstances.
As the headlights are
fitted with plastic
“glass”, it is essential to
use H4 anti U.V. lamps.
(The use of any other H4 bulb
could cause damage to the
headlight.)
It is advisable carry a set of spare
bulbs for emergencies.
To Next Page
Loading...
