18B&OLRBIUDB*T[G3DJH
CLIO nu665-3
C:\Documentum\Checkout\nu665-3_eng_T1.WIN 12/9/2001 11:03
-page49
1.41
INSTRUMENT PANEL (continued)
The presence and operation of the warning and indicator lights described below depend on the car's
equipment and the country.
7 Multifunction display
• Oil level display function
The car must be parked on
level ground and the engine
should have been switched
off for some time beforehand
to obtain an accurate level
reading.
When ignition has been
switched on for
approximately 30 seconds:
- if the level is correct,the
display will show “oil OK”
To ascertain the level more
accurately, press the trip
mileometer reset button.
The squares in the display
indicate the level. The
number of squares
displayed reduces as the oil
level drops and they are
replaced by a dash.
- if the level is at its
minimum,theword“OK”
will not appear on the
display, the dashes and the
word “oil” will flash and
the SERV indicator light
will illuminate.
It is vital to top up with oil
as soon as possible.
• Total mileage recorder, trip
mileage and clock
Canbereadapproximately
30 seconds after switching on
the ignition.
8 Multifunction key
• Display selection
Press briefly to move from
the total mileage to the trip
mileage and vice versa.
• Trip mileage zeroing button
Press the button and hold it
down when the trip mileage
is displayed.
9 STOP warning light
It goes out as soon as
the engine starts.
This lights up together with
one of the warning lights:
9 Engine immobiliser
system warning light
This light performs
several functions. Refer to the
information on the engine
immobiliser in section 1.
SERVICE warning light
This comes on when
the ignition is switched
on and goes out after 3 seconds.
If it lights up while you are
driving, it indicates a
recommendation that you visit
a Renault Dealer in the near
future: if it flashes it is
indicating that there is water in
the diesel.
It lights up together with one of
the warning lights:
Turning left direction
indicator light
To Next Page
Loading...
