Renault Clio - Headlight Beam Adjustment

lighting:
exterior .................................................
(up to the end of the DU)
lights:
adjusting ..............................................
(up to the end of the DU)
lights
adjustment ...........................................
(up to the end of the DU)
headlight beam adjustment .......................
(up to the end of the DU)
signals and lights .......................................
(up to the end of the DU)
electric beam height adjustment ................
(up to the end of the DU)
lights:
adjustment of headlight beam height ...
(up to the end of the DU)
1.106
ENG_UD59089_2
Réglage des faisceaux (XJA - Renault)
Switch A is used to adjust the height of
the headlight beams according to the
load.
With the dipped beam headlights lit,
press or lift switch A as many times
as is necessary to select the required
position on the instrument panel. The
position selected is displayed on the
instrument panel for approximately
30 seconds.
Note: depending on the vehicle, at
each engine start-up the selected po-
sition may be displayed on the instru-
ment panel for approximately 30 sec-
onds.
Headlight beam adjustment
HEADLIGHT BEAM ADJUSTMENT
Examples of positions for
adjusting
control A according to the load
Driver alone or with front passenger 0
All seats occupied 2
Driver with passengers and luggage
(or load) reaching the maximum
permissible all-up weight
3
Driver without passengers and luggage
(or load) reaching the maximum
permissible all-up weight
4
The table below gives some examples. In all cases, adjust control A accord-
ing to the vehicle load so that the road can be seen and other drivers are not
dazzled.
A