EasyManua.ls Logo

Renault Clio - Reagent Tank

Renault Clio
424 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AdBlue .......................................................
(up to the end of the DU)
reagent tank cap ........................................
(up to the end of the DU)
reagent tank capacity ................................
(up to the end of the DU)
reagent quality ...........................................
(up to the end of the DU)
filling with reagent ......................................
(up to the end of the DU)
reagent (tank) ............................................
(up to the end of the DU)
reagent tank...............................................
(up to the end of the DU)
reagent tank capacity ................................
(up to the end of the DU)
SCR: selective catalytic reduction .............
(up to the end of the DU)
Stop & Start ...............................................
(current page)
1.119
ENG_UD71741_6
Réservoir réactif (BJA - Renault)
Filling
Useable capacity of the tank: 2.42
gal (11 litres) approximately.
With the ignition switched off, open the
cover A, then unscrew the cap 1.
Note: ammonium hydroxide vapour
may escape from the cap opening
when the tank temperature is high.
Reagent tank
Please ensure that you comply with the
legislation of your country. It is impor-
tant to remember that failure to respect
regulations in force could lead to legal
action being taken against the vehicle
owner.
Operating principle
The reagent is intended for diesel en-
gines fitted with the SCR (selective cat-
alytic reduction) system.
Using a reagent reduces the quantity of
nitrogen oxides in exhaust gases.
Reagent consumption in real time de-
pends on vehicle usage conditions, the
equipment fitted, and driving style.
Reagent quality
Use only reagents which conform
to standard ISO 22241 and in accor-
dance with the mark on the tank filler
cap.
REAGENT TANK (1/4)
A
1
Fuel filler cap: this is a
specific type.
If you have to replace it,
make sure it is identical
to the original cap. Contact an ap-
proved Dealer. Do not wash the filler
area with a high pressure washer.
To fill up with reagent, the engine
must be stopped (and not on
standby in the case of vehicles
equipped with the STOP and Start
function). You must switch off the ig-
nition 2.4 2.6.
If the “XXX MILES (XXX
KM) failure Top up AdBlue
warning message appears,
fill the reagent tank and
refer to the filling instructions.
Risk of immobilisation of the ve-
hicle.
The reagent must not come into contact with eyes or skin. If it does, wash
the affected area with plenty of cold water. If necessary, consult a doctor.

Table of Contents

Other manuals for Renault Clio

Related product manuals