2.31
ENG_UD73030_2
Limiteur de vitesse (XJK - Renault)
Exceeding the limit speed
It is possible to exceed the limit speed
at any time. To do this: press the accel-
erator pedal firmly and fully (beyond
the resistance point).
While the speed is being exceeded, the
programmed speed displayed on the
instrument panel flashes.
Then, release the accelerator: the
speed limiter function will return as
soon as you reach a speed lower than
the stored speed.
Limited speed cannot be maintained
When driving down a steep gradient,
the system may be unable to maintain
the limited speed: the limited speed
will flash on the instrument panel and,
depending on the vehicle, an audible
signal will sound at regular intervals to
inform you of this situation.
SPEED LIMITER (2/3)
The speed limiter function is
in no way linked to the brak-
ing system.
Driving
When a limited speed has been stored
and provided this speed is not reached,
driving is similar to driving a vehicle
without the speed limiter function.
Once you have reached the stored
speed, no effort on the accelera-
tor pedal will allow you to exceed
the programmed speed except in an
emergency (refer to information on
“Exceeding the limit speed”).
Varying the limit speed
The limit speed may be changed by re-
peatedly pressing:
– switch 2 (RES/+) to increase speed;
– switch 3 (SET/-) to reduce speed.
If the speed limiter is not
available (after several at-
tempts to activate), contact
an approved dealer.
2
3
To Next Page
Loading...
