1.22
FRONT HEADRESTS (1/2)
HeadrestA
To raise the headrest
Pull the headrest upwards to the de-
sired height.
To lower the headrest
Press button 2 and guide the headrest
down to the desired height.
To adjust the angle of the headrest
Depending on the vehicle, push back or
draw the headrest 4 nearer to you until
the desired position.
To remove the headrest
Raise the headrest to its highest po-
sition (tilt the seatback backwards if
necessary). Press button 1 and lift the
headrest to release it.
To refit the headrest
Pull out the headrest rods 3 as far as
possible by pulling from the top. Take
care to ensure they are clean and cor-
rectly aligned and, if there are any prob-
lems, check that the notches are facing
forwards.
Insert the headrest rods into the holes
(tilt the seatback backwards if neces-
sary).
Lower the headrest until it locks, press
button 1 and lower the headrest as far
as possible.
Check that each headrest rod 3 is se-
curely locked in the seatback by trying
to pull them up or push them down.
The headrest is important
for safety. Ensure that it is in
place and in the correct po-
sition: The top of the head-
rest should be as close as possible
to the crown of the head and the dis-
tance between your head and the
headrest should be the least pos-
sible.
2
3
A
1
The three upper positions can
be manipulated without pressing
button 2. However, it is preferable to
press this button to lower the head-
rest.
4
To Next Page
Loading...
