1.23
Headrest B
To raise the headrest
Pull the headrest upwards to the de-
sired height.
To lower the headrest
Press button 5 and guide the headrest
down to the desired height.
To remove the headrest
Raise the headrest to its highest po-
sition (tilt the seatback backwards if
necessary). Press button 5 and lift the
headrest to release it.
To refit the headrest
Pull the headrest rods fully out 6 by pull-
ing from the top. Take care to ensure
they are clean and correctly aligned
and, if there are any problems, check
that the notches are facing forwards.
Insert the headrest rods into the holes
(tilt the seatback backwards if neces-
sary).
Lower the headrest until it locks, press
button 5 and lower the headrest as far
as it will go.
Check that each headrest rod 6 is se-
curely locked in the seatback by trying
to pull them up or push them down.
FRONT HEADRESTS (2/2)
B
5
6
The headrest is important
for safety. Ensure that it is in
place and in the correct po-
sition: The top of the head-
rest should be as close as possible
to the crown of the head and the dis-
tance between your head and the
headrest should be the least pos-
sible.
To Next Page
Loading...
