ENGINE OIL LEVEL
5
Maintenance - 105
Topping up/Filling
The vehicle must be parked on level
ground and the engine should be cold
(for instance, before the engine is
started up for the first time in the day).
Do not exceed the max
level and do not forget to
refit cap
1
.
– Unscrew cap
1
.
– top up the level (as a guide, the
capacity between the minimum and
maximum reading on the dipstick
2
is
approximately 0.85 litres,(depending
on the engine).
– wait for approximately 20 minutes to
allow the oil to flow into the engine.
– check the level using the dipstick
2
(as described above).
Once the level has been read, ensure
that the “cap-type dipstick” is
completely screwed in.
In order to prevent
splashback, it is
recommended that a funnel
be used when topping up/filling
with oil.
Consult an approved dealer
at once if you notice an
abnormal or repeated drop
in any of the fluid levels.
Never run the engine in
an enclosed space as
exhaust gases are
poisonous.
The engine may be hot
during operations in
close proximity. In
addition, the engine
cooling fan may come on at any
moment.
Risk of injury.
Engine oil change : if
you are changing the oil
when the engine is hot,
be careful not to scald
yourself if the oil overflows.
Oil change
Service interval : refer to the
Maintenance Document for your
vehicle.
Oil change capacity
Please refer to the maintenance
document for your vehicle, or contact
an authorised dealer.
Always check the engine oil level using
the dipstick, as explained previously (it
should never fall below the minimum.
To Next Page
Loading...
