WINDSCREEN WIPER - TO LIFT/REPLACE WIPER BLADES
6
134 - Practical advice
To lift the wiper arm 1
– Switch ON the ignition ;
– Move the wiper stalk from park
position
A
(make sure the windscreen
is wet with washer fluid while moving
the wiper) to intermittent wiping/normal
wiping.(Refer to instructions under
Windscreen washing/wiping for wiper
stalk positions in chapter 1) ;
– Switch OFF the ignition once the
wiper reaches position
B
;
– Lift the wiper arm
1
;
– press
3
from inner side of the wiper
arm and push the blade down along
the direction
C
to remove the wiper
blade
2
.
Refitting a wiper blade
To refit the wiper blade, proceed in
reverse order to removal. Make sure
that the blade is correctly locked in
position.
Do not attempt to remove
the dirt from dry windshield
with the wipers or you can
damage the windshield and wiper
blades. Always wet the windshield
with washer fluid before operating
the wipers.
Check condition of the
blades. You are responsible
for their correct
maintenance :
– clean the blades, windscreen
and rear screen regularly with
soapy water ;
– do not use the wipers when the
windscreen is dry ;
– lift them off the windscreen
when they have not been used for
a long time.