2.28
ENG_UD72336_3
Système de surveillance de pression des pneumatiques (X82 PH2 - Renault)
TYRE PRESSURE MONITOR (3/5)
Steps Displays
(depending on
the vehicle)
Messages Readings
1
Tyre pressure init. long press
With the ignition on and the vehicle stationary, start the
resetting the pressure of all four tyres by pressing and
holding the 4 OK switch.
2
Learning Tyre Pressures
The “---” symbols in front of each wheel will flash to in-
dicate that the system has registered the tyre pressure
reset for all four wheels.
3
Tyres location in progress
The “---” symbols in front of each wheel will remain lit.
This system resets the tyre pressure of all four tyres.
You can now drive. The message may remain displayed
during short journeys.
Note: during the reset, tyre pressure monitoring remains
in operation.
4
The pressure value of the four tyres is displayed: the re-
setting procedure is complete and successful.
The table below shows the possible messages related to the tyre resetting procedure.
To Next Page
Loading...
