2.27
ENG_UD72336_3
Système de surveillance de pression des pneumatiques (X82 PH2 - Renault)
TYRE PRESSURE MONITOR (2/5)
Resetting procedure
Ignition on, vehicle stopped:
– tap switch 5 as many times as nec-
essary to reach the Vehicle
tab;
– briefly press the 2 or 3 switch to
reach the “Tyre Pressure” page;
– press and hold (around 3 seconds)
the button 4 to launch the reset. The
flashing tyres followed by the mes-
sages “Learning Tyre Pressures”
and then “Tyres location in progress”
indicates that the reset request for
the tyre pressure reference value
has been acknowledged.
Reset can take several minutes of driv-
ing.
If the resetting is followed by short trips,
the message “Tyres location in pro-
gress” can remain displayed after suc-
cessive restarts.
Note: the standard tyre pressure
cannot be less than that recommended
and indicated on the door frame.
4
2
3
5
For your safety, the warning
light
® requires you
to stop immediately as soon
as traffic conditions allow.
To Next Page
Loading...
