To Next Page

To Previous Page

Contents

Safety ........................................................................1.1

Safety ....................................................................1.1

HSI basics .................................................................... 2.1

Introduction ................................................................2.1

HSI components ............................................................2.2

RENGAGE™ probe connector (3-way) ........................................2.3

Standard probe connector (3-way) ............................................2.3

Controller connector (12-way) ...............................................2.3

ERROR LED ............................................................2.3

STATUS LED ............................................................2.4

PROBE TYPE LED. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.4

Remote device ...........................................................2.4

Solid-state relay (SSR) .......................................................2.5

Probe inhibit function ......................................................... 2.6

12 V to 30 V M-code connected directly to the HSI ...............................2.6

0 V M-code connected directly to the HSI ......................................2.6

M-code driven relay contact .................................................2.7

M-code driven open collector ................................................2.7

HSI dimensions .............................................................2.8

HSI specification ............................................................2.9

System installation ...........................................................3.1

Installing the HSI ............................................................3.1

Typical HSI installation ....................................................3.1

Mounting the HSI to a DIN rail ...............................................3.2

Connecting the HSI to a RENGAGE™ probe and the CNC controller ................. 3.3

Connecting the HSI to a standard probe and the CNC controller ....................3.4

Parts list .....................................................................4.1

Renishaw HSI Installation Guide

Other manuals for Renishaw HSI