Renkforce DL-LED163 - Maintenance; Cleaning; Fuse Replacement

To Next Page

To Previous Page

12. Maintenance

Regularly check the technical safety of the eect spotlight, e.g. for damage to the mains cable or the

casing.

If you have reason to believe that the device can no longer be operated safely, disconnect it immediately

and make sure it is not operated unintentionally. Pull the mains plug from the mains socket!

It can be assumed that safe operation is no longer possible if:

• the device is visibly damaged

• the device no longer works

• the device has been stored under unfavourable conditions for an extended period of time or

• after exposure to extraordinary stress caused by transport

Always observe the following safety instructions before cleaning or servicing the eect spotlight:

Live components may be exposed if covers are opened or components are removed.

The device must be disconnected from all power sources before any servicing or repair work is

carried out.

Capacitors inside the device may still carry voltage even though they have been disconnected

from all power sources.

Only qualiﬁed experts familiar with the hazards involved and the relevant regulations must per

form repairs.

a) Cleaning

The outside of the eect light should only be cleaned with a soft, dry cloth or brush.

Never use any aggressive cleaning agents or chemical solutions as these may damage the surface of the

casing.

b) Fuse Replacement

If you have to replace the fuse, ensure that you only use fuses of the speciﬁed type and rated current (see

„Technical Data“) as a replacement

Never repair fuses or bridge the fuse holder.

• Unplug the mains plug from the mains socket and disconnect the low-voltage cable from the mains

connection (1) at the device.

• Using a suitable screwdriver, carefully open the fuse holder with the faulty fuse next to the mains con

nection.

• Remove the defective fuse and replace it with a new fuse of the indicated type.

• Carefully push the fuse holder with the new fuse back into its position at the mains connection of the

device.

• After this, you can reconnect the device to the mains and take it into operation.