02
Do NOT let the positive (+) and negative (-) terminals of the battery touch each other.
Use Lithium batteries or deep cycle Sealed Lead Acid, Flooded, Gel, AGM batteries.
Explosive battery gases may be present while charging. Be certain there is enough ventila-
tion to release the gases.
Be careful when working with large lead acid batteries. Wear eye protection and have fresh
water available in case there is contact with the battery acid.
Over-charging and excessive gas precipitation may damage the battery plates and activate
material shedding on them. Too high of an equalizing charge or too long of one may cause
damage. Please carefully review the specific requirements of the battery used in the
system.
Battery Safety
The unit should be installed in a well-ventilated, cool, and dry environment. Make sure
the fans of the unit and the ventilation holes are not blocked.
Do not expose the unit to rain, moisture, snow, or liquids of any type.
Installation Safety
To Next Page
Loading...
