19
When the inverter is switched on, the circuitry inside is
activated. Even if there is no load on the AC side of the
inverter, users will experience a small amount of current
draw to keep the circuitry within the inverter ready to
power. It is recommended to turn off the inverter when
not in use.
External Fusing
Fusing is a recommended in PV systems to provide a safety measure for connections
going from panel to controller and controller to battery. Remember to always use the
recommended wire gauge size based on the PV system and the controller.
NEC Maximum Current for different Copper Wire Sizes
To Next Page
Loading...
