Renovator Multi-Tool - Page 29

29
COPPER PIPE CUTTING
BEFORE
AFTER
Application 4: Nail & Screw Cutting
• Select low oscillation frequency.
• Distribute the use of the saw blade evenly to maximise the life of the
saw blades.
Application 5: Pipe Cutting
• Select low oscillation frequency.
• Distribute the use of the saw blade evenly to maximise the life of the
saw blades.
• Using a pendulum motion will allow the blade to make more contact with
the rounded surface of the pipe.
SMALL NAIL CUTTING
LARGE NAIL CUTTING