130
Cube
®
EN
This menu can be used to configure the control as repeater and to set the TouchDisplay as main or
secondary control.
A) Set the control as repeater
Setting a control as a repeater can be useful if the other control is located too far from the
ventilation system. In such a case it is possible that the signal generated by that control does not
reach the fan. The signal will then be passed on to the other control located closer to the fan
which will repeat the signal and pass it on to the fan.
9.1.3.3.6 • Device settings
Select ‘Device settings’ in the Installer menu and confirm with ■.
Select the menu ‘KNX repeater’ with ■.
We recommend only to use this function in cases where it is absolutely necessary.
To Next Page
Loading...
