Need help?Do you have a question about the Renson Cube TouchDisplay and is the answer not in the manual?
General| Power Supply | 24V DC |
|---|---|
| Display Type | TFT LCD |
| Mounting | Wall mount |
| Humidity Range | 10% to 90% non-condensing |
| Certifications | CE |
Instructions on how to dispose of the unit in an environmentally friendly way.
Details environmental conditions to avoid and electrical safety requirements for installation.
Mentions the requirement to perform a linking procedure before connecting the TouchDisplay.
Advises on placing the display on an inner wall at eye level and considerations for open/closed kitchens.
Illustrates connecting the TouchDisplay to the mains power supply with wire specifications.
Details requirements for mounting boxes, including depth and screw hole placement.
Shows the process of single mounting and fitting the surround cover, including antenna placement.
Guides the user on selecting the country to load factory settings.
Details the screen that appears when the fan connection is being updated and a link is established.
Describes the process of pressing the KNX/LINK button and the display confirmation for linking.
Explains the main control menu appearance after a successful link and the "Failed" notification.
Identifies and explains the meaning of the ventilation mode, rate, CO2 level, buttons, program, and clock indicators.
Provides a legend for interpreting CO2 levels based on color and numerical ranges.
Covers Automatic and Manual modes, describing how the system adjusts ventilation levels.
Describes the Boost mode, which provides maximum ventilation capacity.
Explains how secondary "Timer" controls lock the main display and how they are unlocked.
Describes the methods to enter the USER MENU using button combinations.
Lists available USER MENU options: Program, Clock, and Display settings.
Explains how to exit the USER MENU and return to the main control menu.
Shows an example of a predefined ventilation program schedule with times and levels.
Details the process of adjusting the day, hour, and minute indications.
Explains how to set the time before the display enters standby mode.
Covers adjusting brightness for both active and standby modes.
Explains how to change the USER MENU language.
Details how to access the INSTALLER MENU for advanced configurations.
Explains how to configure a TouchDisplay as a main, secondary control, or repeater.
Provides important notes regarding secondary control programming, such as CO2 threshold deactivation and program point limitations.
Details the steps to select and configure the KNX Repeater function.
Guides the user to the CO2 THRESHOLD option within the INSTALLER MENU.
Describes how to set the CO2 concentration threshold and the implications of exceeding limits.
Notes regarding CO2 threshold configuration for main and secondary controls in multi-display setups.
Explains the procedure after a power failure, including re-setting day and clock.
Details error messages like "FAN NOT READY" and "Lost Communication With Fan".
Covers other error codes, specifically "Lost Communication With Fan".
Advises on cleaning the display with a microfiber cloth and avoiding liquids.
Instructs users to contact their installer or the aftersales division for repairs.
Explains the 2-year warranty period, coverage for flaws, and responsibilities.
Clarifies warranty exclusions, handling of damages, and the effect of calibration on warranty.
To Next Page