Renson Cube TouchDisplay - Main or secondary control setting; Programming as Secondary Control

EN 131
Depending on the function of the TouchDisplay it can be configured as a main or secondary
control and/or repeater.
In case this has not been done yet, the TouchDisplay needs to be linked with the ventilator unit.
In order to do so, follow the steps mentioned in section 6: ‘linking the TouchDisplay with the
ventilator unit’.
8.2 • Main or secondary control setting
8.1 • Linking the TouchDisplay with the ventilator unit
8.2.1 • Programming the control setting (main or secondary)
• Select the INSTALLER MENU – DEVICE SETTINGS on the
second- dary control and press n .
➊
The secondary control(s) need to be programmed as ‘secondary control’.