Renu Electronics FlexiPanels Basic FP2043T-E - Product Overview; Installing FP2 with I;Os Products

FlexiPanels
®
Basic HMI
© Renu Electronics Pvt. Ltd.
Page 6 of 24
Product Overview
This section of the manual provides an overview of series with I/Os products, its front and back
view, installation details, dimensional details, mounting method, and details.
Installing FP2 with I/Os products
FP2 series HMI with I/Os series products are designed for front panel mounting. Before installing
the products, the user should review the panel guidelines, panel cutout dimensions, product
dimensions, and minimum clearances.
Panel Guidelines
The panel must be at least 2mm (12gauges) so that it can provide the required support and
proper sealing against water and dust. The panel surface must be flat, without any imperfection,
to maintain the adequate seal and IP rating.
The maximum panel thickness allowed is 6mm (±0.2mm).
Panel Cutout Dimensions
The panel must be at least 2mm (12gauges) so that it can provide the required support and
proper sealing against.
Model
Height (mm)
Width (mm)
FP2043T-E
80
111
FP2043TN-E
80
111
FP2070T-E
127
175
FP2070TN-E
127
175
ATTENTION
ATTENTION: Panel cutout
 Before making a panel cutout, disconnect all electrical power from the panel.
 Make sure that area surrounding the panel cutout is clear.
 Make sure that metal cutting does not enter any component already installed in the
panel.