Reolink Argus Pro Operational Instruction

1. Please click the “ ” button
in the top right corner to add the
camera.
2. Scan the QR code on the back
of the camera.
3. Click “Connect to Wi-Fi” to
configure the wifi settings.
NOTICE:
• Reolink Argus 2/Argus Pro
camera only supports 2.4 GHz
Wi-Fi. 5 GHz is not supported.
• Your family can click "Access
Camera" for live view after the
initial setup.
Download and install the Reolink App on App Store (for iOS) and Google Play (for Android).
Available on the
Get it on
Set up Camera on Reolink App (For Smartphone)
Please follow the prompt tones to configure the camera.
4. A QR code will be generated on the phone. Please place the QR code on your phone towards
Reolink Argus 2 or Pro camera’s lens at a distance of about 20cm (8 inches) to let the camera
scan the QR code. Please make sure that you’ve ripped the protection film of the camera’s lens.
5. Follow the steps to finish the WiFi settings.
6. After you created a password for your camera, please follow the steps to sync the time, and
then start live view or go to “Device Settings”
Add New Device
Device Settings
Menu
Access the Live View
Battery Status
Enable/Disable PIR
Motion Sensor
(In default, the PIR sensor
is enabled.)
20 cm ( 8 inches )
5English4 English
r
≈30cm(12 inch)

Reolink Argus Pro Specifications

General

Field of View	130° diagonal
Audio	Two-way audio
Operating Temperature	-10°C to 55°C (14°F to 131°F)
Motion Detection	PIR motion sensor
Resolution	1920 x 1080 (1080p)
Power Source	Rechargeable battery (solar panel compatible)
Connectivity	Wi-Fi (2.4GHz)
Night Vision	Up to 33 feet
Weatherproof	IP65
Storage	MicroSD card (up to 128GB)
Image Sensor	CMOS sensor
Video Resolution	1080p
Infrared Night Vision	Yes
PIR Detection Distance	Up to 33ft
Wireless Security	WPA2
Battery	5200mAh rechargeable battery
Power	5V/2A