Activated the SIM Card for the Camera
Register on Network
4English3
English
Set up the Camera
1. Remove the back cover by rotating
counterclockwise and insert the SIM
card into the slot.
2. Insert the battery into the camera
and tighten the back cover to power
on the camera.
• The SIM card shall support WCDMA and FDD LTE.
• Activate the card on your smartphone or with your network carrier before inserting
it into the camera.
• Some SIM cards have a PIN code, please use your smartphone to disable the PIN first.
• Do not insert the IoT or M2M SIM into your smartphone.
Camera Introduction
Built-in Mic
Infrared Lights
Status LED
Daylight Sensor
Bult-in PIR Sensor
Micro USB Port
Battery Status LED
Speaker
SIM Card Slot
Micro SD Card Slot
Lens
Reset Hole
*Press the Reset button with a Pin to restore factory settings.
NOTE:
To Next Page
Loading...
