REP ARES - Step 21: Final Hardware Tightening



21
FULLY
TIGHTEN
INSERT WEIGHT SELECTOR PINS (10-0179) INTO THE BOTTOM 1.
WEIGHT STACK PLATES.
FULLY TIGHTEN ALL RACK HARDWARE. 2.
FULLY TIGHTEN ALL ARES BRACKET HARDWARE. 3.
FULLY TIGHTEN ALL PULLEY HARDWARE. 4.
NOTE: TIGHTEN ALL HARDWARE FROM BOTTOM UP.
24MM
2X NOT INCLUDED
2X NOT INCLUDED
36MM
5000 SERIES
2X NOT INCLUDED
17MM