20
2.3 STOP
The system can be stopped as follows:
TEMPORARILY
• Disconnect the power socket and activate the by-pass.
• Disconnect the connection pipes.
• Empty the salt water tank and wash it internally.
• Clean the softener and store it in a dry, weather-proof and exclusively accessible place (do not leave it within the reach
of children or unauthorised persons).
CONCLUSIVELY
In addition to temporary decommissioning the operations, the following are also planned:
• Pack the machine with cardboard, polystyrene or other materials and inform the appropriate personnel (authorised
waste disposal or used take-back).
2.4 RESTARTING AFTER LONG PERIODS OF INACTIVITY
• Always have a qualified and specialised technician check that the system has maintained at the original degree of
protection of the electrical equipment.
• Connect the power supply unit to the machine and check that the timer is working.
• Slowly open the water inlet valve and then start forced regeneration.
• Place 10 litres of lukewarm water and 50 ml of Amuchina in the salt container.
• Wait for the end of regeneration (not before two and a half hours), then open the water outlet valve and close the bypass
valve.
IN CASE OF EMERGENCY / DANGER THE SYSTEM CAN BE STOPPED:
1. By disconnecting the power supply unit;
2. By activating the by-pass.
This will immediately stop the system.
WARNING
Avoid the penetration of water into parts of the system during periods of inactivity to avoid the risk of short circuits or malfunctions.
To Next Page
Loading...
